|
12-18-2013
|
#1 |
 
Join Date: Jan 2004
Location: Murrieta, CA
Posts: 241
|
Secondary plate and screws
We need a secondary plate and screws for a 90 Z.
What is the best way to lock in those secondary plates? Red Loctite?
__________________
91 ZR-1 #661 Watsons, 3" exhaust, Borlas... Hurst, 4.11s, Samco, RD radiator, gel coated motor... turquise / black |
|
|
|
12-18-2013
|
#2 | |
|
Join Date: May 2007
Location: Chicagoland, IL
Posts: 9,708
|
Re: Secondary plate and screws
Quote:
__________________
[SIGPIC][/SIGPIC]Former Membership Chairman Former ZR-1 Registry - BOD 1972 Corvette 4speed base Coupe SOLD long time ago 1984 Corvette Z-51/4+3 SOLD 1992 Corvette ZR-1 Aqua/Gray #474 SOLD 1992 Corvette ZR-1 Black Rose/Cognac #458 2014 Honda VFR Interceptor DX |
|
|
|
|
|
12-19-2013
|
#3 |
Join Date: Jul 2004
Location: Kalamazoo MI
Posts: 1,752
|
Re: Secondary plate and screws
These?
I'm sure I have screws I just was going through my parts last night. If your talking about the two screws that hold the plates on the shaft some loctite will be fine.
__________________
JOHNNY P Currently own 90 ZR-1 #845 DRM 500 engine package 90 #226 Parts car Hit me up if you need anything. Last edited by phrogs; 12-19-2013 at 01:31 PM. |
|
|
|
|
12-19-2013
|
#4 |
|
Join Date: Jan 2004
Location: Murrieta, CA
Posts: 241
|
Re: Secondary plate and screws
Thanks Johnny. Were already good to go on this. We only needed a butterfly plate and screws. Larry already ordered these parts from Jerry.
Never heard back from you on the ZF-6 trans I have. You still looking for a used trans ?
__________________
91 ZR-1 #661 Watsons, 3" exhaust, Borlas... Hurst, 4.11s, Samco, RD radiator, gel coated motor... turquise / black |
|
|
|
|
12-20-2013
|
#5 |
|
Join Date: Jul 2004
Location: Kalamazoo MI
Posts: 1,752
|
Re: Secondary plate and screws
No not at the moment but No worries.
__________________
JOHNNY P Currently own 90 ZR-1 #845 DRM 500 engine package 90 #226 Parts car Hit me up if you need anything. |
|
|
|
 |
|
|
Linear Mode
