|
07-15-2013
|
#1 |
 Join Date: Mar 2013
Location: Roswell, GA
Posts: 234
|
Removing the ignition coils and starter
I have the intake plenum off the car and would like to do some cleaning of the general area. I was told to remove the coils and starter first. Is there anything special I should know to do this? Can the coils be removed as an assembly or do they need to be removed one at a time? is the the starter shimmed? Thanks..
__________________
1995 ZR1 #159 Ported,Corsa,4.10 Rear, Dual Disc RAM Clutch, Alum Flywheel, Haibeck Chip, ZFDoc Plates, Relocated Battery 400 rwhp 1992 ZR1 #280 Ported, Locked Secondary's, Flowmaster Exhaust, Haibeck Chip, 375rwhp 1996 Collectors LT4 (Stock) 1972 Convertible 434 Small Block 572 rwhp |
|
|
|
07-15-2013
|
#2 |
 
Join Date: Dec 2003
Location: Chicagoland,IL
Posts: 2,679
|
Re: Removing the ignition coils and starter
Disconnect battery.
Coils come off as one unit two 8mm screws in front two 10mm screws in back you will also need to take off the spark plug wire loom from each side held down with injector housing screw you can't miss them and take coils with spark plug wires right off. Pete
__________________
'91 #1635 PoloGreen 350 LT5 11.09 @ 129.27 11.04 @ 128.86 474RWHP 400RWTQ http://www.youtube.com/watch?v=SFNFOhGGlR4 http://www.youtube.com/watch?v=ZlRIOMwaDYY https://sites.google.com/site/peteszr1garage |
|
|
|
 |
|
|
Linear Mode
