|
03-27-2011
|
#1 |
 Join Date: Jan 2004
Location: Portland, OR
Posts: 1,057
|
Sleeve Thickness
I'm trying to verify the thickness at the top of a stock cylinder liner, can someone with a motor apart mic this for me? I checked my 368 liners and they are .075 thick so I think stock should be .125in.
__________________
Robert ZR-1 Net Registry Oregon State Director 91 ZR-1 #431 Black/Black LPE 368 |
|
|
|
03-27-2011
|
#2 |
|
Join Date: Apr 2009
Location: Prather, CA
Posts: 809
|
Re: Sleeve Thickness
Not sure which dimension you mean, so I'll give you three of them. I took these measurements with a digital caliper on the stock liner that I removed from my '90 LT5.
Liner wall (outer to inner edge) is .295" Liner wall at the flat is .245" The ridge at the top of the liner (I think this is the dimension you want?) is .100"
__________________
[IMG]http://i13.photobucket.com/albums/a292/bdw18_123/_zr1netforumsigphoto.jpg[/IMG][B] 1990 Corvette ZR-1 [/B][I] White/Flame Red, #2299, mostly stock, 144K miles.[/I] -Cams timed to the '93-'95 405HP LT5 stock timing. -IAT sensor relocated to below front bumper. -Haibeck hoops installed in airduct. -OBX cat-back exhaust. [COLOR=DarkRed][B](SOLD - December 2012 [/B][/COLOR][COLOR=DarkRed][B]:hello:)[/B][/COLOR] 1993 Corvette Coupe Black/Black, 6-speed (SOLD - October 2009 :hello:) |
|
|
|
|
03-27-2011
|
#3 |
|
Join Date: Jan 2004
Location: Portland, OR
Posts: 1,057
|
Re: Sleeve Thickness
Thanks guys! The measurement that Cliff posted in the pic is the one I was curious about.
__________________
Robert ZR-1 Net Registry Oregon State Director 91 ZR-1 #431 Black/Black LPE 368 |
|
|
|
 |
|
|
Linear Mode
