couple a quick ?'s

[32valvZ]

First, why does my LTPWS light come on everytime I drive for a little while? I dont have any air loss in any tire.

Second, does anyone know a part number for the reverse light switch on the ZF.........I assume it would be the same as a regular C4 with the ZF, but I want to double check that.
TIA

LTPWS is garbage. My suggestion is to pull them out as they are a hazard when driving at speed. But more than likely the power generator is going out on it.


Back up light is #10159402

[32valvZ]

Originally Posted by Jeffvette

LTPWS is garbage. My suggestion is to pull them out as they are a hazard when driving at speed. But more than likely the power generator is going out on it.


Back up light is #10159402

just to reiterate...this is the switch on the tranny...not a light correct?

Correct, it's a pain to get out.

[32valvZ]

Originally Posted by Jeffvette

Correct, it's a pain to get out.

Ok, thanks Jeff...yea, it will be a tight area to fit a wrench in, but I think I can get to it......I can always "manipulate" one of my old non Snap-On wrenches to fit up there or an old socket. It almost looks like if I were to take a drift and tap it with a hammer, I could break off the plastic enough to easily get a socket to fit in there with a small breaker bar.....

Should I expect my local GM dealer to have this?

I would not expect them to. The Reno warehouse shows 2 in stock and the LA warehouse shows 6 available.

[32valvZ]

Originally Posted by Jeffvette

I would not expect them to. The Reno warehouse shows 2 in stock and the LA warehouse shows 6 available.

Yea, I basically meant they can order it for me if I ask for that specific pt#...sorry for being unclear. thanks again....

[Aurora40]

FYI, I ordered the switch from Bill B, and he sent along a tool he'd fabbed up. Worked like a charm, and I shipped him the tool back along with a check.

[Jason 91]

I need to do the same thing to mine. What is the special tool?

Thanks,

Jason

[Aurora40]

It was just a box wrench only he like welded on another box wrench head IIRC, so it was deeper.