WTB: 3 Pcs front lower air dam

[bob@tradeshowconsulting.c]

Can anyone recommend the best replacement front 3 pcs black plastic front air dam that most matches the original OEM one. Mine is original and very scuffed up.
Looking to buy a new one, and there are many out there. But wanted recommendations from people who know the best one to get thats closest to OEM

Thanks

Bob 93 ZR1.

[AirbusDriver]

I've purchased three complete NOS sets over the last year on ebabe. If NCRS is in yur future, make sure you get the original, assembly line part numbers. Otherwise, repop is the way to go.

[bob@tradeshowconsulting.c]

Originally Posted by AirbusDriver

I've purchased three complete NOS sets over the last year on ebabe. If NCRS is in yur future, make sure you get the original, assembly line part numbers. Otherwise, repop is the way to go.

Yes I would Preferer NOS, However, haven't seen any NOS ones on eBay lately

Thank You anyways

[AirbusDriver]

Mid-America sells a three piece unit that appears like original in config...until you find a NOS set.

[Mystic ZR-1]

Mine came from Corvette America @ Carlisle.
Very reasonable $.
Believe it or not, the quality is better than OEM...
NCRS probably wouldn't agree?

[GOLDCYLON]

Originally Posted by AirbusDriver

I've purchased three complete NOS sets over the last year on ebabe. If NCRS is in yur future, make sure you get the original, assembly line part numbers. Otherwise, repop is the way to go.

I have to agree here. Unless you are going for NCRS just get a quality repro from any of the parts houses. After a month on the car it will be back to getting scraped up pretty fast. GC

[DRM500RUBYZR-1]

If your existing factory pieces are all scraped on the bottom edge, simply remove them and carefully file down the edge evenly far enough to remove most if not all of the damage.
While it may not be perfect it retains originality if NCRS pursuits should beckon.
Should they notice during judging, you might have a small deduction for condition, but far better than losing all of the points due to non originality.

You may also install the repro for use other than NCRS, and re-install the smoothed out one for judging.

There are many products out there that will restore the color and low sheen close to original.


Marty

[bob@tradeshowconsulting.c]

Done all that ...and there are scrapes on the face that wont come off or restore.
All damage done by previous owner and Im experienced enough and care enough
to not ever scrape a new one or NOS one..

Just want the recommended closest repro one to oem and if I can get a NOS I would preferer that

Thanks All

[Jagdpanzer]

Over the years I seen several reproductions that were near perfect knockoffs of originals even including the molded in numbers lettering on the backside. I'll look around at Carlisle next week.Image1660829392.952180.jpg


Sent from my iPhone using ZR-1 Net Registry

[jrd1990zr1]

I have both the left and the right side NOS air deflectors, still have the GM parts tags attached. I do not have the center section. I think I paid $55.00 each for them. I'm thinking $110.00 for both plus insured trackable shipping. Payment by PayPal friends and family. If you want photos, I'll have to take them and post them.

I have an aftermarket set of the 3 parts, if you want those $60.00 plus insured trackable shipping.