|
03-18-2019
|
#1 |
 
Join Date: Nov 2007
Location: Sunshine State
Posts: 1,071
|
Exhaust Questions
So we finally had a custom exhaust shop open in my area... very fortuitous for us both since I need some work done...
I have Watson headers in already and 2 new MF bullet cats I would like installed, and then an X pipe. Looks like there are several choices for the X pipe on the SW site... not sure which to order https://stainlessworks.net/products/...builds/x-pipes Questions: 1. What size 2.5 or 3.0" 2. Placement of said X pipe 3. Where do you guys typically clamp vs weld? Id like to see some pics you guys might have of a finished system with headers, cats & X pipe if you have... Thanks, John
__________________
[B]1990 #2815[/B] [COLOR="Red"][B]Red/Red[/B][/COLOR] Ported Plenum & IH (by Pete) Haibeck Chip Rebuilt FPR (by Phil) FIC Injectors Watson LT Headers 3" Stainless Works exhaust Lingenfelter Open Air Lid Bill B Built Transmission Shifter & C Beam Plates [FONT=Impact][COLOR=red]1992 [COLOR=black]#[/COLOR] 091[/COLOR][/FONT] [FONT=Impact][COLOR=#ff0000]Red/[COLOR=silver]Gray[/COLOR][/COLOR][/FONT] [B]SOLD[/B] |
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
