|
08-16-2018
|
#1 |
 Join Date: Mar 2013
Location: Roswell, GA
Posts: 234
|
My Brakes Don't Seem Fully Release
My brakes seem to grab a bit even when my foot is not on the pedal. My ebrake is off. If my car is in neutral and not in gear, I can not push it. I don't go through brake pads so it is not much but more than I see with my other cars. I expect some drag but not that much. Any thoughts as to what could be the cause?
__________________
1995 ZR1 #159 Ported,Corsa,4.10 Rear, Dual Disc RAM Clutch, Alum Flywheel, Haibeck Chip, ZFDoc Plates, Relocated Battery 400 rwhp 1992 ZR1 #280 Ported, Locked Secondary's, Flowmaster Exhaust, Haibeck Chip, 375rwhp 1996 Collectors LT4 (Stock) 1972 Convertible 434 Small Block 572 rwhp |
|
|
|
08-16-2018
|
#2 |
 
Join Date: Aug 2009
Location: South Dakota/California
Posts: 3,797
|
Re: My Brakes Don't Seem Fully Release
Caliper pistons are sticky and need a cleaning is my first guess.
Slides on Caliper are sticky is second guess. Remove Calipers and give them a good cleaning and a new coat of red paint when you are there 
__________________
Left Clickable links  -Solutions- LT5 Modifications/Rebuild Tricks Low Mileage ZR-1 Restoration 1990 Corvette (L98) Modifications LT5 Eliminated Systems LT5 Added Systems LT5/ZR-1 Fluids 1995 LT5 SPECIFIC TOP END REBUILD TRICKS Last edited by Dynomite; 08-16-2018 at 10:53 PM. |
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
