New clutch master - ZR-1 Net Registry Forums

SharkPilot · 03-08-2007

I'm once again fixing my red Beast.

The clutch master started leaking. I am going to replace both the master and slave. My question regards the slave. I have read about lots of them having the seal installed backwards. Is this still a problem? I'm not afraid of taking this one apart but would rather not do it if it's not necessary.
It is a genuine GM part #12509313 that I just purchased today.

As always... Thanks for the help.

SharkPilot

03-08-2007

Supposidly the new ones are corrected. Call Bill and talk to him

www.zfdoc.com

SharkPilot · 03-08-2007

Thanks Jeff, I'll give him a call tomorrow.

Did you check out the photos of the charcoal? I replaced the canister and blew out the purge line and replaced the purge valve. With two new coils and a set of wires the engine is running very well. Smooth as a... well you know.

Now I just need to get these cylinders installed.

Jim

03-08-2007	#2
Jeffvette Guest Posts: n/a	Re: New clutch master Supposidly the new ones are corrected. Call Bill and talk to him www.zfdoc.com

03-08-2007	#3
SharkPilot Join Date: Aug 2005 Location: Anaheim, California Posts: 105	Re: New clutch master Thanks Jeff, I'll give him a call tomorrow. Did you check out the photos of the charcoal? I replaced the canister and blew out the purge line and replaced the purge valve. With two new coils and a set of wires the engine is running very well. Smooth as a... well you know. Now I just need to get these cylinders installed. Jim

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

03-08-2007	#1
SharkPilot Join Date: Aug 2005 Location: Anaheim, California Posts: 105	New clutch master I'm once again fixing my red Beast. The clutch master started leaking. I am going to replace both the master and slave. My question regards the slave. I have read about lots of them having the seal installed backwards. Is this still a problem? I'm not afraid of taking this one apart but would rather not do it if it's not necessary. It is a genuine GM part #12509313 that I just purchased today. As always... Thanks for the help. SharkPilot __________________ [CENTER][SIGPIC][/SIGPIC] 1991 ZR-1 #1135 Red/Red with both tops. Stock except for an open topped K&N filter.[/CENTER]