coolant part needed - ZR-1 Net Registry Forums

Terry Callihan · 01-24-2007

I have a minor coolant leak,the piece i need is a 90 degree elbow that hooks to a hose right off the air plenum.the hose looks to be in good shape,but the 90 turns and won't tighten down into the plenum.

65ZR1 · 01-24-2007

I may be wrong on this, but I thought the tubes were pressed in with a bit of sealant. If the tube is still good then pop it out, clean it and put it back with a bit of sealant. Im not sure what sealant the factory used. Hopefully someone can verify. Good lucK!

01-25-2007

Crush fitting. Pull it out, use a little JB weld on it or some kind of epoxy and hope it doesn't blow out at 7,200 RPM.

BTW, the pipe is discontinued.

01-24-2007	#1
Terry Callihan Join Date: Jan 2007 Location: wurtland,KY. Posts: 3	coolant part needed I have a minor coolant leak,the piece i need is a 90 degree elbow that hooks to a hose right off the air plenum.the hose looks to be in good shape,but the 90 turns and won't tighten down into the plenum.

01-24-2007	#2
65ZR1 Join Date: May 2006 Location: Canada Posts: 139	Re: coolant part needed I may be wrong on this, but I thought the tubes were pressed in with a bit of sealant. If the tube is still good then pop it out, clean it and put it back with a bit of sealant. Im not sure what sealant the factory used. Hopefully someone can verify. Good lucK!

01-25-2007	#3
Jeffvette Guest Posts: n/a	Re: coolant part needed Crush fitting. Pull it out, use a little JB weld on it or some kind of epoxy and hope it doesn't blow out at 7,200 RPM. BTW, the pipe is discontinued.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode