|
12-14-2015
|
#1 |
 
Join Date: Feb 2010
Location: Ochlocknee, GA
Posts: 435
|
stage one cam specs
OK,
So i'am sitting here 12 days after having my right shoulder replaced. and someone asked me what are my cam specs on my 368 cu in stage one cam motor ( 1990 ). So how do if out or can someone tell me. As far as my shoulder goes, during real good I go in tomorrow for first PT evaluation. The only bad thing is i can't drive the ZR-1 for 3 weeks or more. thanks, John 1990 white/black auto ( 4l80E ) eq ZR-1 |
|
|
|
12-14-2015
|
#2 | |
Join Date: May 2010
Location: Japan
Posts: 3,581
|
Re: stage one cam specs
Quote:
I guess it depends on who designed the Stage I cams you have. If South Georgia Corvette (Aaron Scott), it will be: lift .420, duration 230 degrees at .050 for both intake and exhaust cams
__________________
Craig "ZR-1 NO KA 'OI" "ZR-1 ICHIBAN" 1995 #228 Black/Black with Dunn Heads ZR-1 owner since September 2003 ZR-1 Net Registry Founding Member #0074 NCM Lifetime Member #2048 
|
|
|
|
|
|
12-14-2015
|
#3 |
|
Join Date: Feb 2010
Location: Ochlocknee, GA
Posts: 435
|
Re: stage one cam specs
Craig,
thanks for the information , The motor was built by Arron Scott @ SGC. back in Jan 2009 .I cannot find my build sheet for the information. The 6-speed was replaced with an auto back in Aug 2004.She has run the best of 11.58 @ 120.00 in the 1/4 mile. Thank you John 1990 white/black #2546 one of a few auto ( 4l80E ) eq. ZR-1's |
|
|
|
|
12-15-2015
|
#4 |
|
Join Date: May 2010
Location: Japan
Posts: 3,581
|
Re: stage one cam specs
You're welcome John. I've always admired that car of yours. I have the same cams are the only reason I knew the specs. Regards, Craig
__________________
Craig "ZR-1 NO KA 'OI" "ZR-1 ICHIBAN" 1995 #228 Black/Black with Dunn Heads ZR-1 owner since September 2003 ZR-1 Net Registry Founding Member #0074 NCM Lifetime Member #2048
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
