|
03-17-2014
|
#1 |
 
Join Date: Jul 2005
Location: Las Vegas, Nevada
Posts: 777
|
Clutch Master cylinder
Any preferred brand for this part? Bendix? ACDelco? Wagner? etc.
Thanks
__________________
JB 1990 #148 Red/Saddle Haibeck AYBKG5 Chip/RC Engineering/Flowmasters/K&N/Samco/Fuzzy Dice :cheers: |
|
|
|
03-17-2014
|
#2 |
|
Join Date: Nov 2011
Location: Dunbarton NH
Posts: 7,492
|
Re: Clutch Master cylinder
|
|
|
|
|
03-17-2014
|
#3 |
 
Join Date: May 2005
Location: Georgia Mountains
Posts: 927
|
Re: Clutch Master cylinder
changed master & slave a couple of years ago ... went with Jim at powertorque (link above) after spending a good bit of time searching what to get and discovering a very high incidence of incompatibility and subsequent failure with anything non-original. Contact Jim ... you won't be disappointed.
|
|
|
|
|
03-17-2014
|
#4 |
|
Join Date: Jul 2005
Location: Las Vegas, Nevada
Posts: 777
|
Re: Clutch Master cylinder
I got my slave from Jim a few years back. Great guy! I changed the master and slave about 5-6 years ago. The new slave was bad so I got a new one from Jim. I didn't think they had a problem with the master's, but mine just went bad. I know it is the master because it is leaking inside. Anyhow, I guess that I will be talking to Jim.
Thanks guys!!
__________________
JB 1990 #148 Red/Saddle Haibeck AYBKG5 Chip/RC Engineering/Flowmasters/K&N/Samco/Fuzzy Dice :cheers: |
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
