|
07-24-2006
|
#1 |
 Join Date: Dec 2005
Location: Fort Payne, AL
Posts: 4
|
Oil pressure gage reads high
First time post, need info on high oil pressure reading. My ZR-1 (90 #2940) oil pressure gage pegs out and will only drop to 3/4 when engine warms up and is at idle. Per the GM bulletin 91-451A-8C I replaced the sensor (from Tom Henry Chevy) hoping to clear up the problem. After installing the new sensor, gage registered a little over 3/4 on start up of warm engine and dropped to 1/2 at idle. All seemed well as I reved engine, pressure increased and never exceeded the 3/4 mark. Patted self on back and called it a night. Next day cranked up only to once again see the gage pegged out. Drove around for about 30 minutes and gage dropped to 3/4 at idle but would peg out as rpm's increased. Anyone have any ideas, Thanks for your time.
|
|
|
|
07-24-2006
|
#2 |
Join Date: Feb 2006
Location: Iowa aka "one big cornfield"
Posts: 341
|
Re: Oil pressure gage reads high
was there any oil at the connector?.....did you clean the connector by spraying contact cleaner inside the connecting slots?...thinking there might have been some oil there that have run down overnight and given you a bad reading just as if the sender was leaking again
|
|
|
|
|
07-24-2006
|
#3 |
 
Join Date: Dec 2003
Location: McHenry, Il.
Posts: 6,607
|
Re: Oil pressure gage reads high
  Snap-On Oil Pressure Gauge Set - MT37 - $40 (santa clara) Reply to: sale-183323693@craigslist.org Date: 2006-07-18, 7:39AM PDT Up for sale is a Snap-On Oil Pressure Gauge Set, MT37. It is in the metal case, and included with male adapters. If interested please email me. http://sfbay.craigslist.org/sby/tls/183323693.html click here for the link  Welcome to the site good luck on the fix!
__________________
http://i119.photobucket.com/albums/o...9mcw/SIG-2.jpg http://i119.photobucket.com/albums/o128/wb9mcw/vcm.gif "The Budget should be balanced, the Treasury should be refilled, public debt should be reduced, the arrogance of officialdom should be tempered and controlled, and the assistance to foreign lands should be curtailed, lest Rome will become bankrupt. People must again learn to work instead of living on public assistance." - Cicero, 55 BC " We the people are the rightful masters of both Congress and the courts, not to overthrow the Constitution but to overthrow the men who pervert the Constitution." - Abraham Lincoln Last edited by WB9MCW; 07-24-2006 at 11:18 PM. |
|
|
|
|
07-25-2006
|
#4 |
|
Join Date: Dec 2005
Location: Fort Payne, AL
Posts: 4
|
Re: Oil pressure gage reads high
No oil leaks were in old sensor, contact still shiny and new, car only has 2500 miles on it. I traced the wire as far back to the plenum and it appears to be good to that point. I think I will connect a manual gage to see what actual read is and trace the wires entire lenght.
|
|
|
|
|
07-26-2006
|
#5 |
|
Join Date: Jan 2004
Location: Southern CA
Posts: 108
|
Re: Oil pressure gage reads high
The shop manual gives a procedure using specific value resistors in place of the sensor to see if the gauge is reading properly.
|
|
|
|
|
07-28-2006
|
#6 |
Join Date: Oct 2004
Location: Woods Cross, UT
Posts: 389
|
Re: Oil pressure gage reads high
Just go to the Auto Parts Store and buy a new one and throw it in and try it. They are cheap...less than $20...and there's nothing special about them.
__________________
Uly Past OWNER 90 ZR-1 #0120 Red/Saddle UT Plate: EZR1DER |
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
