|
02-26-2011
|
#1 |
 
Join Date: Jul 2004
Location: Kalamazoo MI
Posts: 1,753
|
need a part number for the power steering return line
The one from the cooler to the steering rack.
Soft line going into a hard line clamped ends
__________________
JOHNNY P Currently own 90 ZR-1 #845 DRM 500 engine package 90 #226 Parts car Hit me up if you need anything. |
|
|
|
02-27-2011
|
#2 |
Join Date: Dec 2004
Location: Jacksonville, FL USA
Posts: 4,645
|
Re: need a part number for the power steering return line
90 - 91 P/N 26016988
91 - 95 P/N 26033592 This is from the parts CD that Kurt burnt. The P/N's are old numbers that have proly been changed? Also, according to the CD you can't get just the hose you reference. It has N/S where the P/N would be, I figure that means No Stock? The numbers I listed are a package with that hose & the clamps & a nut. I just tried the P/N's @ GM direct and it seems that they are NLA.
__________________
1990 ZR-1, Black/grey, #2233, stock. ZR-1 Net Reg Founding Member #316 & NCM member |
|
|
|
|
02-27-2011
|
#3 |
|
Join Date: Jul 2009
Location: Redding Calif
Posts: 223
|
Re: need a part number for the power steering return line
You might give O' Rielly's or NAPA a call with that part #. They both were able to cross reference it to after market parts stock for me when I was working on another problem.
__________________
1994 ZR-1 # 0102...SOLD |
|
|
|
|
02-27-2011
|
#4 |
|
Join Date: Jul 2004
Location: Kalamazoo MI
Posts: 1,753
|
Re: need a part number for the power steering return line
humm.
What about the demensions? Length, outisde and inside diameters?
__________________
JOHNNY P Currently own 90 ZR-1 #845 DRM 500 engine package 90 #226 Parts car Hit me up if you need anything. |
|
|
|
|
02-28-2011
|
#5 |
Join Date: May 2010
Location: Japan
Posts: 3,587
|
Re: need a part number for the power steering return line
Johnny,
I took mine to a hydraulic hose shop when I could not find the hose and they just cut off the connector and gave me a hose and clamps. They told me it would cost more than worth to make a hose and since low pressure no issue; it was worked fine since. Not the NCRS solution, but works great.
__________________
Craig "ZR-1 NO KA 'OI" "ZR-1 ICHIBAN" 1995 #228 Black/Black with Dunn Heads ZR-1 owner since September 2003 ZR-1 Net Registry Founding Member #0074 NCM Lifetime Member #2048 
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
