|
11-25-2010
|
#1 |
 
Join Date: May 2007
Location: Westminster, Maryland
Posts: 3,688
|
WTB - C-Beam Bolts
I want to buy two C-Beam bolts, 1 front (transmission end) and one rear (differential end). I am going to try to make alignment pins to make C-Beam installation easier.
Email or PM if you have some extra C-Beam bolts to sell or trade. Jim
__________________
If it isn't fun, you aren't doing it right! 1990 Black ZR-1 - sold 1993 Quasar Blue ZR-1 1994 Competition Yellow ZR-1 1995 Dark Purple ZR-1 Maryland State Coordinator WAZOO Member |
|
|
|
11-25-2010
|
#2 |
Join Date: Apr 2007
Location: Northern VA
Posts: 2,662
|
Re: WTB - C-Beam Bolts
Jim, what do you have on your mind?
I've had good results lining the C-Beam holes up using an 18" rolling head pry bar.  Phil |
|
|
|
|
11-25-2010
|
#3 | |
 
Join Date: Mar 2004
Location: Found Member
Posts: 4,345
|
Re: WTB - C-Beam Bolts
Quote:
|
|
|
|
|
|
11-25-2010
|
#4 |
|
Join Date: May 2007
Location: Westminster, Maryland
Posts: 3,688
|
Re: WTB - C-Beam Bolts
Hi Phil,
I had some trouble (a few minutes of prying) getting the last one we did back together. I am thinking about putting a taper on the thread end of the bolts and use them as a close fit alignment tool. I saw a pry bar like yours at the store but figured that if it fit in the back end hole, it would be too big for the front holes. Jim |
|
|
|
|
11-26-2010
|
#5 | |
|
Join Date: Mar 2009
Location: Orlando, FL
Posts: 1,827
|
Re: WTB - C-Beam Bolts
Quote:
|
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
