|
09-09-2009
|
#11 | |
|
Join Date: May 2009
Location: S Nevada
Posts: 351
|
Re: Header install
Quote:
Service manual states Final pass torque of 35Ft Pounds for the manifold stud. Last edited by Kb7tif; 09-09-2009 at 06:56 PM. |
|
|
|
|
09-12-2009
|
#12 |
|
Join Date: May 2009
Location: S Nevada
Posts: 351
|
Re: Header install
.
|
|
|
|
|
09-12-2009
|
#13 |
 
Join Date: Jul 2007
Location: Bartlett, IL
Posts: 7,156
|
Re: Header install
you get them both installed?
__________________
1990 Corvette ZR-1 #1051 Watson Headers (2" Primary) - Flowmaster Cats - Borla Catback Late Model IH - Plenum Coilovers - 4.10s Shelby Series 1 - Wilwood Brakes Custom Interior NCM Lifetime Member #978 |
|
|
|
|
09-12-2009
|
#14 | |
|
Join Date: May 2009
Location: S Nevada
Posts: 351
|
Re: Header install
Quote:
No rush here just works until it gets hot. The exhaust should connect up with some adapters (3" band clamps). I prepared for the worst and got a mig welder set up and I will make whatever is needed. |
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
