HELP - LT5 Idle Air control connector

[WVZR-1]

This is a release tool that will reach a "Pull To Seat" terminal tab. The actual GM/Delphi tool was just a 'vise device' with a twist to tighten like a Dremel etc. You need to enter the rear of the shell.

Delphi vice is a 12180559-1 Understanding the length and the very small awl type point I'm sure the creative mind can sort it. Release shouldn't be an issue.

https://www.amazon.com/Rennsteig-Sup.../dp/B00A8GL7NA

If this link works it would be the GM/Delphi device.

https://www.ebay.co.uk/itm/GM-Delphi...75.c100623.m-1

[jrd1990zr1]

I found a vendor for the connector and terminals.

https://www.bmotorsports.com/shop/index.php

They look to have all the connectors we would need.

Thanks to all for the help. John

[tpepmeie]

Yes. They are quite good, I use them often.




Sent from my iPhone using ZR-1 Net Registry

[jrd1990zr1]

Got the replacement connector and terminals from Ballenger Motor Sports. Made the new connection, looks like OEM.

Thanks to all for the advice and help.

John

[Ccmano]

Originally Posted by jrd1990zr1

Got the replacement connector and terminals from Ballenger Motor Sports. Made the new connection, looks like OEM.

Thanks to all for the advice and help.

John

Did you get the pigtail and splice it in?
H

[jrd1990zr1]

Hans,

I bought a new connector and terminals from Ballenger Motorsports and installed the connector, new crimps. Did not want to splice in pigtails. Wanted it to appear OEM.

John

Originally Posted by Ccmano

Did you get the pigtail and splice it in?
H

[Ccmano]

Originally Posted by jrd1990zr1

Hans,

I bought a new connector and terminals from Ballenger Motorsports and installed the connector, new crimps. Did not want to splice in pigtails. Wanted it to appear OEM.

John

Nice... what are the part #s? I have to do mine too.
Thanks
H

[XfireZ51]

Originally Posted by jrd1990zr1

Hans,

I bought a new connector and terminals from Ballenger Motorsports and installed the connector, new crimps. Did not want to splice in pigtails. Wanted it to appear OEM.

John

John,

There’s enough wire to do that? I need to replace mine also.

[jrd1990zr1]

Originally Posted by Ccmano

Nice... what are the part #s? I have to do mine too.
Thanks
H

Ballenger Motorsports. Link in my previous message above.
CONN-75638 GM Delphi / Packard - 4 way metripack 150.2 sealed male connector Kit for iac, black

The terminals are PULL 2 SEAT, in other words you release them from the wire side with a double prong tool. Push them out the front.

Jim Voter's post shows a picture of the tool. I removed the short section of conduit to give some room for the repair. Pulled the rear rubber back to access the rear of the plug, then released the 4 wires one at a time. I opened up the rear crimp on each metal terminal and cut the old terminal off. I only lost about 1/8 inch of each wire. Moved the wires to the new connector and crimped new terminals on then seated them into the plastic connector. Just remember you crimp the terminals on AFTER the wire goes thru the connector. Put the conduit back on. Pretty simple job actually, sorry I waited so long to fix it.

John

[Paul Workman]

Just as an "FYI", another supplier I've used and had good experiences with (connectors and such) is Del City.