SLP Claw, but not about horsepower - Page 2 - ZR-1 Net Registry Forums

ZR1 MK · 03-21-2006

Quote:

Originally Posted by Aurora40

If it's no trouble, sure. Did it have any affect on power?

The mufflers are 3 inch straight through with packing around them for a total diameter of 4 inch. They wont affect power output. They did quiet the system, but not in a tremendous way.
Its hard to actually determine noise level differences, because Im inconsistent as to my tolerances. The exhaust was quiet and awesome this past Saturday afternoon, but this morning to work it was annoying.

Kevin · 03-23-2006

Quote:

Originally Posted by Aurora40

I knew I should have taken a pict when I put the decal on it...

stupid question: could you have it on upside down?

Aurora40 · 03-23-2006

Quote:

Originally Posted by Kevin

stupid question: could you have it on upside down?

It's symetrical. I don't believe there's an up or down side to it. I put the sticker on the same side as the "samco" sticker in case I wanted a cleaner look, I could just flip it over.

Locobob · 03-25-2006

The SLP claw is slightly easier to install than the factory air box. It's a nice quality piece. I had mine powder coated to match the engine and have been working on a cold air scoop for into to get air from under the front bumper. Here's what I have so far.

03-25-2006	#14
Locobob Join Date: Jan 2004 Location: Portland, OR Posts: 1,057	Re: SLP Claw, but not about horsepower The SLP claw is slightly easier to install than the factory air box. It's a nice quality piece. I had mine powder coated to match the engine and have been working on a cold air scoop for into to get air from under the front bumper. Here's what I have so far. __________________ Robert ZR-1 Net Registry Oregon State Director 91 ZR-1 #431 Black/Black LPE 368

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode