Removing Secondary Vacuum System questions.

[billybaloneey]

Originally Posted by VetteVet

I pulled my receipt and it was definitely the 555-108's that I used. They were a snug fit, but that's a good thing.

I used red Loctite to seal and used a socket that filled most of the cup, but allowed the sides to flex when driving them.

I picked up 8 of the 555-011's at O'Rielys yesterday...they were only $0.49 each. I'll do a test fit/installation, and if it's to loose I'll try one of the 108's. If I have an odd size secondary bearing hole, I'll try Paul's approach...JB Weld.

NOTE THIS DAY IN ZR-1 HISTORY: a part used on a ZR-1 only costing $0.49