A/C Compressor Clutch - ZR-1 Net Registry Forums

rebelz · 04-09-2008

Well... Here we go again! Is it possible to R&R an A/C Compressor Clutch without removing the Compressor from the car? I guess one run to 7000 RPM without turning the A/C to the "off" position fried it. I wasn't doing an all out run, just a spirited acceleration through 1st to Second gear, so I didn't think about shutting it off. Evidently it tried to engage at or near peak RPM. I can't find a procedure in the FSM, Chiltons or Haynes to even do an R&R of the clutch but they sell the compressors sans clutch so I guess it's possible to replace them. Any help would be greatly appreciated.
REBel

tomtom72 · 04-09-2008

I just looked in my 90's Helm FSM and as near as I can tell it appears that you actually can do an r & r on the clutch assembly....except they call it a pressure plate & not a clutch.

If you like I can transcribe the steps & e-mail them to ya.

Oh, there is a special tool, J 33027-A clutch hub holding tool. It's for r 7& r'ing the compressor shaft bolt.....I may be wrong but why can't ya just use an air impact gun on that???

Let me know if ya need me to send the step by step to ya. Oh, fwiw, our compressors are auto shut off if rpms reach 4K....

modern electronics are wonderful....no?

Tom

sorry I forgot this, I bought a spare from a rebuilder in TX complete with the clutch...$450.00...found him on e-bay. I could send that info along if ya think ya want to check him out?

gbrtng · 04-09-2008

Quote:

Originally Posted by rebelz

Well... Here we go again! Is it possible to R&R an A/C Compressor Clutch without removing the Compressor from the car? I guess one run to 7000 RPM without turning the A/C to the "off" position fried it. I wasn't doing an all out run, just a spirited acceleration through 1st to Second gear, so I didn't think about shutting it off. Evidently it tried to engage at or near peak RPM. I can't find a procedure in the FSM, Chiltons or Haynes to even do an R&R of the clutch but they sell the compressors sans clutch so I guess it's possible to replace them. Any help would be greatly appreciated.
REBel

Hmmm ... I thought the A/C clutch would drop out at full throttle and above a certain RPM, and not engage under those conditions either. Todd: please add your knowledge about the ECM programming.

rebelz · 04-10-2008

Tom PM sent.
REBel

tomtom72 · 04-10-2008

Quote:

Originally Posted by rebelz

Tom PM sent.
REBel

PM sent back to you to acknowledge. I will comply asap.

Tom

04-09-2008	#1
rebelz Join Date: Jul 2007 Location: Anchorage, AK Posts: 106	A/C Compressor Clutch Well... Here we go again! Is it possible to R&R an A/C Compressor Clutch without removing the Compressor from the car? I guess one run to 7000 RPM without turning the A/C to the "off" position fried it. I wasn't doing an all out run, just a spirited acceleration through 1st to Second gear, so I didn't think about shutting it off. Evidently it tried to engage at or near peak RPM. I can't find a procedure in the FSM, Chiltons or Haynes to even do an R&R of the clutch but they sell the compressors sans clutch so I guess it's possible to replace them. Any help would be greatly appreciated. REBel __________________ REBelZ '92 ZR-1 Yellow/Black #031

04-09-2008	#2
tomtom72 Join Date: Dec 2004 Location: Jacksonville, FL USA Posts: 4,645	Re: A/C Compressor Clutch I just looked in my 90's Helm FSM and as near as I can tell it appears that you actually can do an r & r on the clutch assembly....except they call it a pressure plate & not a clutch. If you like I can transcribe the steps & e-mail them to ya. Oh, there is a special tool, J 33027-A clutch hub holding tool. It's for r 7& r'ing the compressor shaft bolt.....I may be wrong but why can't ya just use an air impact gun on that??? Let me know if ya need me to send the step by step to ya. Oh, fwiw, our compressors are auto shut off if rpms reach 4K.... modern electronics are wonderful....no? Tom sorry I forgot this, I bought a spare from a rebuilder in TX complete with the clutch...$450.00...found him on e-bay. I could send that info along if ya think ya want to check him out? __________________ 1990 ZR-1, Black/grey, #2233, stock. ZR-1 Net Reg Founding Member #316 & NCM member Last edited by tomtom72; 04-09-2008 at 06:58 AM.

04-10-2008	#4
rebelz Join Date: Jul 2007 Location: Anchorage, AK Posts: 106	Re: A/C Compressor Clutch Tom PM sent. REBel __________________ REBelZ '92 ZR-1 Yellow/Black #031

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode