|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
12-22-2020
|
#1 |
 
Join Date: Jan 2006
Location: Decatur, AL
Posts: 1,119
|
Is the exhaust stud in the head of any use after stock manifold replacement
So, I reinstalled both studs with Loctite 565 in the heads today in anticipation of bolting on the headers tomorrow. Is there any reason to reinstall the nut on the studs? I installed the studs until they were fairly tight (all the way to where the non threaded section started), I am afraid if I put the nuts back on the stud they may twist as I tighten them and break the thread seal loose and I don't want an oil leak. Thanks.
__________________
Corvette95 Registry and Forum (*************) 1989 C4 Conv Wht/Gry Auto Hardtop Top Flight SOLD 1995 C4 Coupe Purple/Blk 6 Speed 1989 C4 Conv Wht/Red Auto SOLD 1996 C4 Conv Black/Tan Auto SOLD 1994 C4 Coupe Wht/Blk SOLD 1995 C4 ZR-1 White/Gry #278 Dual Dunn Head SOLD 1986 C4 Coupe Black/Red 4+3 SOLD 1990 C4 ZR-1 Red/Red #0454 |
|
|
|
12-22-2020
|
#2 |
 
Join Date: Dec 2003
Location: Arcadia,OK
Posts: 3,394
|
Re: Is the exhaust stud in the head of any use after stock manifold replacement
No. The original purpose of the center stud was to hang the manifolds during assembly at BG.
__________________
Jerry Downey JERRYS LT5 GASKETS & PARTS http://www.jerrysgaskets.com 1994 ZR-1, Black/Black, Lingenfelter Aerobody, 416cu in, 3.91 gears, coil-over susp, Brembo brakes, etc. 2016 Black-Red, 3LT-Z51 Auto 8-speed. |
|
|
|
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
