|
03-20-2016
|
#1 |
 Join Date: Mar 2013
Location: Roswell, GA
Posts: 234
|
How deep to install pilot bearing?
My plan was to measure existing but the bronze bushing sspun in the bore and just fell out. Soooo, I see probably where it goes as the inner bore in the crank is stepped. Thought I would double check. I have the FSM but don't believe it is called out there. Thanks!
Update: 10-5-2016: Drive it in until it hits the shoulder. That puts it at about where Racinfan83 states below.
__________________
1995 ZR1 #159 Ported,Corsa,4.10 Rear, Dual Disc RAM Clutch, Alum Flywheel, Haibeck Chip, ZFDoc Plates, Relocated Battery 400 rwhp 1992 ZR1 #280 Ported, Locked Secondary's, Flowmaster Exhaust, Haibeck Chip, 375rwhp 1996 Collectors LT4 (Stock) 1972 Convertible 434 Small Block 572 rwhp Last edited by KJL; 10-05-2016 at 10:47 PM. |
|
|
|
04-20-2016
|
#2 |
 Join Date: Apr 2013
Location: Eastern Missouri
Posts: 773
|
Re: How deep to install pilot bearing?
14.5 mm +/- .5 mm Mine went in to 14.9 and seemed to stop there.
__________________
[LEFT][SIGPIC][/SIGPIC][/LEFT] [CENTER][COLOR=Indigo][SIZE=4][I][B] **Now Sold** 1990 ZR-1 #2093, Black on Black..[/B][/I][/SIZE][/COLOR][/CENTER] |
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
