3D Printing - ZR-1 Net Registry Forums

KPW · 04-09-2016

A few weeks back I picked up a small 3D printer and I've been learning how that world works. Drew up this guy tonight, thought I'd share.

It's not really to scale, I just googled the emblem for reference and took some liberties (shortcuts?) with how accurately to lay it out. Pretty close though, I suppose.

Anyone else here do any 3D printing?

RUSSELL · 04-09-2016

I have one still trying to figure out the cad stuff. I have printed the goofy stuff that you find on thingverse . either way that is awesome.

Russell
91 #1501 POLO GREEN
15 SLIVER HELLCAT
16 BLACK Z06

KPW · 04-09-2016

Russell, what are you using as far as CAD software? I've been using Google Sketchup since it's free. It works pretty well, but sometimes I find it to be a bit limited depending on what I'm trying to do. A lot of that could be user error though...

There are some very nice software packages out there, but they're really expensive, and usually subscription based on top of that.

RUSSELL · 04-09-2016

Honestly I haven't even tried any software yet. I did get a cheap 3d scanner to play with but haven't had the time to play with it. I will try the google sketchup and play with that.

04-09-2016	#2
RUSSELL Join Date: May 2008 Location: Brownwood Texas Posts: 119	Re: 3D Printing I have one still trying to figure out the cad stuff. I have printed the goofy stuff that you find on thingverse . either way that is awesome. Russell 91 #1501 POLO GREEN 15 SLIVER HELLCAT 16 BLACK Z06

04-09-2016	#3
KPW Join Date: Jul 2015 Location: Ypsilanti, MI Posts: 116	Re: 3D Printing Russell, what are you using as far as CAD software? I've been using Google Sketchup since it's free. It works pretty well, but sometimes I find it to be a bit limited depending on what I'm trying to do. A lot of that could be user error though... There are some very nice software packages out there, but they're really expensive, and usually subscription based on top of that.

04-09-2016	#4
RUSSELL Join Date: May 2008 Location: Brownwood Texas Posts: 119	Re: 3D Printing Honestly I haven't even tried any software yet. I did get a cheap 3d scanner to play with but haven't had the time to play with it. I will try the google sketchup and play with that.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

04-09-2016	#1
KPW Join Date: Jul 2015 Location: Ypsilanti, MI Posts: 116	3D Printing A few weeks back I picked up a small 3D printer and I've been learning how that world works. Drew up this guy tonight, thought I'd share. It's not really to scale, I just googled the emblem for reference and took some liberties (shortcuts?) with how accurately to lay it out. Pretty close though, I suppose. Anyone else here do any 3D printing?