Jumper to avoid being stranded with a failed Primary Fuel Pump

[WVZR-1]

These I believe would be the correctly "indexed" shells for the harness:

12020832 looks to be indexed A @ 12:00 (black) and D @ 3:00 (green/white) with the latch on top, this is what is currently on the sender with female terminals in it. Several vendors have that shell. 12020830 should be an appropriate shell for mating and would require just the appropriate male terminals. I don't know why you would need the CPA but 12020833 would get you that if you wanted a couple.

15324982 should be the correct green seals for the individual wires in the connectors.

I'll post back with what I believe should be the appropriate terminals. I don't recall the wire sizes and I'll need Jim to verify the indexing of the shell on the tank unit. I'm doing that mostly from memory but I believe it's appropriate.

Mouser it appears seems to have the correct shells and the CPA. Just use the part numbers I mentioned above to search. They could be available from many others and I don't buy often from Mouser but I've had good service in the past. Their "minimum" best I recall was very realistic and if someone was doing a few of these it would likely be appropriate to just let that person do the procuring from whomever. I didn't check the vendor I use for these part numbers.

http://www.mouser.com/

12089040 for male terminals I believe (I assumed .5 - .8 wire) and 12089188 for the female terminal.

Part #'s required per car:

12020832 X 1, 12020830 X 1, 15324982 X 8, 12089040 X 4, 12089188 X 4 and 12020833 X 1 if you wanted the CPA.