Top end clatter / lifter tick? - ZR-1 Net Registry Forums

mike100 · 03-01-2015

When I helped get Erik's 91 running again after 4 years of storage, it sounded bad and was running on 7 cylinders. After a 4 or 5 mile run down the road (with new oil of course) it was running on 8 and sounded fine. You may need to genuinely get the oil all the way to temp and at some rev to get the higher pressures if the lifters are in need of hydraulic priming.

03-01-2015	#20
mike100 Join Date: Feb 2011 Location: San Marcos CA Posts: 1,786	Re: Top end clatter / lifter tick? When I helped get Erik's 91 running again after 4 years of storage, it sounded bad and was running on 7 cylinders. After a 4 or 5 mile run down the road (with new oil of course) it was running on 8 and sounded fine. You may need to genuinely get the oil all the way to temp and at some rev to get the higher pressures if the lifters are in need of hydraulic priming.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode