Rear End Gear Ratio Change

[Jagdpanzer]

On a few of the Dana 44 gear changes I've done I converted the carrier caps from 1/2" grade 5 bolts over to 1/2" ARP studs.
ARP Part Numbers:
4 x Stud - AR4.060-LB
4 x Hex Nut - 200-8607
4 x Washer - 200-8514
To order call ARP Order Desk & Technical Support: 800.826.3045
Use a 1/2"-13 bottoming tap to deepen the threads in the housing.

[USAZR1]

Originally Posted by WVZR-1

Clint,
When I mention "short-axles" I'm speaking of the left and right shafts that are retained in the differential with "snap-rings" and they're generally considered as "part of" 3d member but it would be possible for someone to offer up a build less those axles and the buyer would use his to complete it. I'd say the buy is reasonable and a person would need to question only the "clutch pack" maybe. If that were fresh I'd say it's a real good buy.

Thanks for the info,Dave. You can tell I've never had a Dana 44 apart.