|
01-13-2013
|
#1 |
|
Join Date: Dec 2012
Location: NC
Posts: 1,786
|
Is this factory harness routing? [snappic]
It's forward in the passenger side foot area...
|
|
|
|
01-13-2013
|
#2 |
|
Join Date: Jun 2010
Location: back in lone pine
Posts: 591
|
Re: Is this factory harness routing? [snappic]
no it isn't. what is the fast unit for ? you have 2 extra fuses ?????tyler could tell you for sure .
|
|
|
|
|
01-13-2013
|
#3 |
 
Join Date: Feb 2010
Location: Ochlocknee, GA
Posts: 435
|
Re: Is this factory harness routing? [snappic]
No,
It looks like its your transmission controller and wiring.I hid mine in my glove box. I used a transmission control unit by Compushift . John Becker 1990 # 2546 |
|
|
|
|
01-13-2013
|
#4 | |
|
Join Date: Dec 2012
Location: NC
Posts: 1,786
|
Re: Is this factory harness routing? [snappic]
Quote:
 The controller is for the automatic transmission that just went in. And I'm believing that the shop that did the swap did this. I'll know for sure tomorrow, when I follow the harness. And this is new too: 
|
|
|
|
|
|
01-14-2013
|
#5 |
 
Join Date: Sep 2012
Location: Rockwall, Tx
Posts: 1,510
|
Re: Is this factory harness routing? [snappic]
It looks like that yellow wire has been pinched almost to the point of being cut off. Look at the indentation in the wire right before it disappears.
__________________
_________________ 1994 AB/Grey #141 430 RWHP/392 RWTQ FBI Lyposuction / Secondaries relieved of duty / SW Long Tube Headers / Corsa Exhaust / FIC SS Injectors / MSD Coils / Lightweight Pulleys / Corey tuned B & M Shifter / Aluminum Flywheel / Samco Hoses / Shelby Series One's / C4 No Flex Frame Stiffener BBC - Bling By Carter: Custom ZR-1 Center Caps / Custom Plenum Plate / Air Box Knobs / TB Cover / Oil Filter Cover |
|
|
|
|
01-14-2013
|
#6 |
|
Join Date: Feb 2011
Location: Salinas, Ca
Posts: 160
|
Re: Is this factory harness routing? [snappic]
Be carefull, yellow wires like that are part of the air bag system.
|
|
|
|
|
01-14-2013
|
#7 | |
|
Join Date: Oct 2004
Posts: 1,890
|
Re: Is this factory harness routing? [snappic]
Quote:
If the "yellow" is a "sleeve/sheath" over existing other wires yes it is an SIR related harness. If it's a stranded wire just yellow in color it was more likely just a poor color choice. If it is SIR in a '90MY the DERM/SIR is top of tunnel and is "orange" in color, harnesses in and out are yellow sheathed. Just follow the yellow to where it's terminated. Were you provided with the hand-held unit that accompanies the TCU controller? Here's a link to the install sheets for the TCU unit I believe you have. I was attempting to ID the loose connector on the floor board. Does it need attention? Don't know! TCU/CONTROLLER INSTALL INSTRUCTIONS: http://news.compperformance.com/Inst...s/CPG5-103.pdf |
|
|
|
|
|
01-14-2013
|
#8 | |
|
Join Date: Dec 2012
Location: NC
Posts: 1,786
|
Re: Is this factory harness routing? [snappic]
Quote:
Yes Sir Bob, and I am VERY familiar with airbags. Today at the tranny shop, with the Tech 1 plugged in, it started fading in, and out INF RES (or something)... I hit one @ 55 once - 55 - 0 in ZERO, ZERO exaggeration - it's all on the report, head on with drinker, also going 55+, SQUARE. Still broke 6 ribs on the steering wheel, 3 bilateral in the pattern of the wheel (amongst other 'breakage') WAH |
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
