![]() |
#11 |
![]() Join Date: Jan 2008
Location: Wichita, Ks.
Posts: 318
|
![]()
My '90 was also very hard to get a good read, so don't feel bad....I generally checked as others have said after sitting overnight....It also used a bit more, than I have noticed with the '94. the '90s did not have valve guide seals, so I figured it was normal to burn off some......just another one of the racey '90 things.
![]()
__________________
2009 LS9 1990 LT-5/sold/Bought my Baby back 1994 Lingenfelter LT-5/sold 1973 LS4/sold |
![]() |
![]() |
![]() |
#12 |
![]() Join Date: Nov 2011
Location: Dunbarton NH
Posts: 7,540
|
![]()
I believe most cars are calibrated to be read after about five minutes of engine off, such as checking on the road. I really depends on how Chevy intended it to be read. I think Porche is meant to be read while the engine is running. That way there is always the same amount of oil in suspention.
|
![]() |
![]() |
![]() |
#13 | |
![]() Join Date: Feb 2011
Location: San Marcos CA
Posts: 1,786
|
![]() Quote:
|
|
![]() |
![]() |
![]() |
#14 | |
![]() Join Date: Apr 2012
Location: Austin, TX
Posts: 54
|
![]() Quote:
This is one of those instances when it would be wonderful if someone who attended the LT5 Gang Reunion in Stillwater last August could email one of the folks on the LT5 team and get the answer. John |
|
![]() |
![]() |
![]() |
#15 |
![]() ![]() Join Date: Feb 2010
Location: Pendleton, IN
Posts: 3,899
|
![]()
I feel confident that if I do a cold check first thing in the morning, I should have a very accurate reading to go by. Just my opinion.
__________________
1988 KOH Prototype EX5023 sold 1990 ZR-1 #444 Convertible 1990 ZR-1 Black #966 1991 ZR-1 Quazar Blue #296 1957 Duntov SS Project Last edited by Blue Flame Restorations; 07-15-2012 at 09:49 PM. |
![]() |
![]() |
![]() |
#16 |
![]() Join Date: Nov 2011
Location: Dunbarton NH
Posts: 7,540
|
![]()
So wouldn't a good test be to do an oil change, put in exactly the right amount of oil, 8.8 quarts in my case, and then see where it falls on the dipstick. Sitting overnight is certainly going to give an accurate and consistant reading, but that all hinges on where GM put the full mark.
Just checked my owners manual. It says check the oil when the engine is cold, that means it sat for hours. Apparently Chevy wants all the oil in the pan to check it. |
![]() |
![]() |
![]() |
#17 | |
![]() Join Date: Jan 2009
Location: Portland Oregon metro area (Washington side)
Posts: 3,193
|
![]() Quote:
__________________
Scott ![]() Vett owner since 1979._It's about the car and the people |
|
![]() |
![]() |
![]() |
#18 | |||
![]() Join Date: Dec 2003
Location: Arcadia, OK
Posts: 3,392
|
![]() Quote:
Quote:
Quote:
Simple, safe, good practice is to let it drain overnight, then refill with 9qts. Drive it, park it overnight, check the level in the morning & top it off, usually 0.2~0.5 qts.
__________________
Jerry Downey JERRYS LT5 GASKETS & PARTS http://www.jerrysgaskets.com 1994 ZR-1, Black/Black, Lingenfelter Aerobody, 416cu in, 3.91 gears, coil-over susp, Brembo brakes, etc. 2016 Black-Red, 3LT-Z51 Auto 8-speed. |
|||
![]() |
![]() |
![]() |
#19 | |
![]() Join Date: Apr 2012
Location: Austin, TX
Posts: 54
|
![]() Quote:
John |
|
![]() |
![]() |
![]() |
Thread Tools | |
Display Modes | |
|
|