Waxing Around Logos

[Socalerv]

Okay, I am the guy that when I wax a car I always have a great deal of clean up around the logos and lettering. Is there a secret of not getting wax where it belongs and not? Also what works best of getting wax off of lamo lens and molding?

[carter200]

Originally Posted by Socalerv

Okay, I am the guy that when I wax a car I always have a great deal of clean up around the logos and lettering. Is there a secret of not getting wax where it belongs and not? Also what works best of getting wax off of lamo lens and molding?

Erv,
I always use a wax that goes on clear and does not haze up. Solves your problems for me. Good luck. Try having your problem on a BLACK car...

[Dylan@Adams]

Taping... at least thats the way I go, that and just using a steady hand in tight areas. A few minutes with blue or green masking tape BEFORE you start working will save you an hour or more of cleanup later.

[robbz28]

I know this is an older post, but I'm new but do have a solution to this problem. I am also a motorcycle rider and I use a product on it called "Original Bike Spirits- Roadside Detailer" I don't think I have used water to wash my bike in several months. I have been using it long enough on bikes to know that it's not going to hurt any plastic or paint. The PO of my car did a quick wax job on it before I bought it and had tons of wax stuck in the cracks. I used a micro fiber rag and a little of my Bike Spirits and it made short work of the leftover wax. I also used it on my 1991 wheels to clean between the slots.

[DennisC]

Use a detailing toothbrush type with microfiber cloth, the brush reaches up close then wipe w cloth

[We Gone]

Been using one of these for years works great. Around emblems dash and any other area I can reach with it. Sonic Scrubber

http://compare.ebay.com/like/1907441...Types&var=sbar

[Racinfan83]

My car had wax all over the center molding strip when I got it. Three applications of Mother's Back to Black got 95% of it off. Thinkin the next time I do it should get the rest. I waxed the car yesterday with Meguiars Poly and I taped off the trim and emblems first with blue painters tape. The Meguiars seemed to not fill the body gaps with white stuff as bad as most others I have used....

[32valvesftw]

Old post but a good quality paint brush works for me.

[lfalzarano]

I tried the brush tricks for many years, but that was time consuming. I found an easier solution.

Once you've cleared the car cracks, and logo's of the wax, use a synthetic wax, like Mequiar's NXT Generation Tech Wax® 2.0. $20 and it is better than wax and won't yellow.

On the engine use a quality paint cleaner and follow with a polishing coat. Do not use wax to seal it. Let it go with just the polish. Same for the wheels.

[32valvesftw]

The new synthetic waxes are awesome thats for sure, I also use NXT good stuff.