Extrude Honing?

[SillyB]

Originally Posted by Paul Workman

There's "better" and there's "best".

I would agree 100% here. I had my stuff ported years ago, before I really started to read this forum. I was trying to replicate the DRM 500/415 so I followed their process, which is "better" than stock. After talking to Marc Haibeck about his hand porting a few years later I realized that I had left some ponies on the table, and that his work would have been "best".

Oh well, no use crying over spend $. Either way it helps keep you in front of those C5s!

[Paul Workman]

[QUOTE=SillyB;107039Either way it helps keep you in front of those C5s![/QUOTE]

AND C6s