Header install questions. - ZR-1 Net Registry Forums

Paul Workman · 05-23-2010

The 5 of you that expressed an interest in me making them a dipstick tube bracket to secure the dipstick when using the Stainless Works headers...Your brackets are ready. I'll get them mailed out Monday and let ya know 'bout the cost. I'll PM ya (you know who you are).

They are a little crude, as the grinding is not machined, but done w/ a hand-held grinder, doancha know. But, that is not visible when the bracket is installed and the bracket itself is rather obscure, normally.

I'll PM each of y'all.

P.

05-23-2010	#9
Paul Workman Join Date: Nov 2007 Location: Squires (near Ava MO in the Mark Twain N'tl Forest) - Missouri Posts: 6,493	Re: Calling all that wanted dipstick tube brackets... The 5 of you that expressed an interest in me making them a dipstick tube bracket to secure the dipstick when using the Stainless Works headers...Your brackets are ready. I'll get them mailed out Monday and let ya know 'bout the cost. I'll PM ya (you know who you are). They are a little crude, as the grinding is not machined, but done w/ a hand-held grinder, doancha know. But, that is not visible when the bracket is installed and the bracket itself is rather obscure, normally. I'll PM each of y'all. P. __________________ Good carz, good food, good friendz = the best of timez! 90 #1202 "FBI" top end ported & relieved Cam timing by "Pete the Greek" Sans secondaries Chip & dyno tuning by Haibeck Automotive SW headers, X-pipe, MF muffs Former Secretary, ZR-1 Net Registry