1/2 way through 1st plenum pull - ZR-1 Net Registry Forums

902066 · 04-22-2010

Just got done pulling plenum and fuel rail, [never done it before]. Have new injectors mounted in rail. I pretty much followed Mark Haibecks dvd.

Surprized to find 1/4" bolt that holds electrical connector to the back of the ignition module was only finger tight. Surprized area under plenum was as dirty as it was for a car with only 10 thou. original miles.

Bumbed that even after being real patient and careful, two injectors pulled out of the bottom of the fuel rail while trying to take off of engine, [minor gas spill in valley]. Those 2 injectors were incredible tight in the housing.

Putting it all back together tommorow, have to take wife out to supper now, and watch the NFL draft tonight. Overall, plenum pull is not that intimidating, changing CCM 5 years ago was way more involved. Only consern now is getting that electrical connection with the 1/4" bolt on correctly and tight.

04-22-2010	#1
902066 Join Date: Jul 2005 Posts: 190	1/2 way through 1st plenum pull Just got done pulling plenum and fuel rail, [never done it before]. Have new injectors mounted in rail. I pretty much followed Mark Haibecks dvd. Surprized to find 1/4" bolt that holds electrical connector to the back of the ignition module was only finger tight. Surprized area under plenum was as dirty as it was for a car with only 10 thou. original miles. Bumbed that even after being real patient and careful, two injectors pulled out of the bottom of the fuel rail while trying to take off of engine, [minor gas spill in valley]. Those 2 injectors were incredible tight in the housing. Putting it all back together tommorow, have to take wife out to supper now, and watch the NFL draft tonight. Overall, plenum pull is not that intimidating, changing CCM 5 years ago was way more involved. Only consern now is getting that electrical connection with the 1/4" bolt on correctly and tight.