Installing HID Driving Lights

Alright ordered my kit from the Labor Day special. Ordered with the 5000k bulbs. Package arrived all nice and neatly packed. Nothing was broken or damaged while in transit.

First things, instructions are a little vague. There are several issues with that. The year break down is not the same 84 - 89 then 90 and then following with 91-96. My install is on a 90 ZR-1. So it has the last year of the old front bumper and the new rad stack.

1) Remove the airbox assembly. This gives you all the room in the world to work. Otherwise the bulb insertion is a tedious task.


2) Start by twisting the bulb holder and pulling the assembly straight back and at the end you will probably need to make it take a slight angle to get it all the way out.







3) You will then need to separate the original wire harness and connector off of the bulb holder.

Shot of the bulb holder and the new HID light.





4) Take your new bulb and string the wires through and make sure the guide slots are going into the bulb assembly. You can see the guides where the bulb is tilted back. Make sure the bulb then seats properly and locks into place on the side locking tabs.



Locked into place