Rear Bumper Molding Question - ZR-1 Net Registry Forums

4DSZR1 · 09-09-2009

I've been thinking about this and as having a little experience in plastics. If the main varianble in the part is in width (distance from the license plate opening to the corner) could'ne one use a donor piece and add length? It would be easy to add a section using quaility glues, scab a piece on the back, and then fill any inperfections with good plastic putty and paint. No one would ever know....

I'm going to try and find some cheap pieces from junkyard and experiment a little.

09-09-2009	#11
4DSZR1 Join Date: Dec 2005 Posts: 692	Re: Rear Bumper Molding Question I've been thinking about this and as having a little experience in plastics. If the main varianble in the part is in width (distance from the license plate opening to the corner) could'ne one use a donor piece and add length? It would be easy to add a section using quaility glues, scab a piece on the back, and then fill any inperfections with good plastic putty and paint. No one would ever know.... I'm going to try and find some cheap pieces from junkyard and experiment a little.