ZR-1 Net Registry Forums  

Go Back   ZR-1 Net Registry Forums > C4 ZR-1 > C4 ZR-1 General Postings

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 01-03-2009   #11
32valvZ
 
32valvZ's Avatar
 
Join Date: Nov 2007
Location: Sunshine State
Posts: 1,071
Default Re: Vibration.

My limited thoughts are these ...... You say it was since the last rip to the drags, hmm. The things that are stressed the most would be clutch, transmission, U-joints, axle shafts and their U-joints. I would probably add in the motor mount as well, but from your description, I'm not 100% sold on that.

I would think that maybe the pilot bushing or the input shaft bearings could be the culprit. I say that because its happening on hard acceleration.

It almost sounds like there may be a combination of problems. The hum can be wheel bearing related as mentioned, or still a bad U-joint. U-joints are hard to pin down sometimes because alot of times, they dont make it obvious that theyre bad, unless theyre totally shelled.

Well, thats my .02
__________________
[B]1990 #2815[/B]
[COLOR="Red"][B]Red/Red[/B][/COLOR]
Ported Plenum & IH (by Pete)
Haibeck Chip
Rebuilt FPR (by Phil)
FIC Injectors
Watson LT Headers
3" Stainless Works exhaust
Lingenfelter Open Air Lid
Bill B Built Transmission
Shifter & C Beam Plates


[FONT=Impact][COLOR=red]1992 [COLOR=black]#[/COLOR] 091[/COLOR][/FONT]
[FONT=Impact][COLOR=#ff0000]Red/[COLOR=silver]Gray[/COLOR][/COLOR][/FONT]
[B]SOLD[/B]
32valvZ is offline   Reply With Quote
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 03:23 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright ZR-1 Net Registry 2020