![]() |
#1 |
Join Date: Jun 2024
Location: Canada
Posts: 6
|
![]()
Good day all,
First time vette owner here, I just picked up a 1991 ZR1 here in Canada. Honestly this community and seeing the support around for the ZR1 played into my decision to pick it up. Unfortunately, it didn't pass inspection; there is a tiny bit of slop between the rack and pinion assembly and tie rod end (couldn't even notice it on the steering wheel). I have a couple questions for you folks: -It looks as is the regular C4 vette assembly is the same as the ZR1? Here is the one I am looking at ordering: https://www.rockauto.com/en/moreinfo...t=7388&jsn=917 -Is there any DIY around on pulling this out and is it much different with the LT5 vs the regular vette engine? -I assume the 1991 Corvette shop manual applies to the ZR1 as well? Not sure if there would be anything on doing the rack and pinion assembly in that? I seen there was a seperate LT5 one as well, I will likely just order both. Any help/suggestions is appreciated! Trevor |
![]() |
![]() |
|
|