Door panel won't go back right - ZR-1 Net Registry Forums

Jetjock · 05-10-2020

I pulled the right door panel off to replace the outside weatherstrip. I put the door panel back and I had a huge gap up front where none was before. All of the screws went back where they were supposed to go. I've had the door panel off three times and each time, it's a different issue. I did replace the Velcro strip but that didn't work. It seems that the screw up front of the door down low and is about two inches long won't hit the screw retainer. I have to pull up on the panel to make it fit. That causes the top of the panel to not catch the upper part of the door. Thoughts.

I'm pulling the panel off tomorrow and try to reset the long screw to where it will fit.

Roy

05-10-2020	#1
Jetjock Join Date: Mar 2008 Location: Auburn, KY Posts: 551	Door panel won't go back right I pulled the right door panel off to replace the outside weatherstrip. I put the door panel back and I had a huge gap up front where none was before. All of the screws went back where they were supposed to go. I've had the door panel off three times and each time, it's a different issue. I did replace the Velcro strip but that didn't work. It seems that the screw up front of the door down low and is about two inches long won't hit the screw retainer. I have to pull up on the panel to make it fit. That causes the top of the panel to not catch the upper part of the door. Thoughts. I'm pulling the panel off tomorrow and try to reset the long screw to where it will fit. Roy __________________ Roy L. Carman If I feel the need for speed, I just think about flying the B-777. 1989 Dk Blue Coupe lost in divorce 1991 Black Coupe SOLD 1992 Black ZR-1 #423 SOLD! 1993 Ruby Red 40th Anniversary ZR-1 #334 1995 Black ZR-1 taken by ex-wife 2002 Pewter Coupe no idea where it is 2003 50th Anniversary Corvette #No idea what number SOLD! ZR-1 Net Registry #516 Grand Sport Lifetime Member NCM Lifetime #1468 ZR-1 Net Registry Board Secretary