Motor alignment after replacing motor mounts ? - ZR-1 Net Registry Forums

5ABI VT · 12-21-2019

Finally got back working on the Z and I replaced the motor mounts with the prothane billet mounts. I did not re-install the k members yet (was pulling and cleaning all the front pan bolts first) but had a question about engine position. With the new mounts installed the engine clearly has room to move and the holes are slotted. Is there a measurement or procedure for positioning the LT5 ? I did notice the mounts I removed had little pins to locate them.

12-21-2019	#1
5ABI VT Join Date: Jun 2013 Location: Toronto Posts: 783	Motor alignment after replacing motor mounts ? Finally got back working on the Z and I replaced the motor mounts with the prothane billet mounts. I did not re-install the k members yet (was pulling and cleaning all the front pan bolts first) but had a question about engine position. With the new mounts installed the engine clearly has room to move and the holes are slotted. Is there a measurement or procedure for positioning the LT5 ? I did notice the mounts I removed had little pins to locate them.