Checking secondary actuators... - ZR-1 Net Registry Forums

32valvZ · 01-20-2008

Ok, so I went down & picked up my new vacuum pump today & checked the actuators. I came up with 15hg needed to fully pull one side & 19hg for the other side.

Am I supposed to do this with all the linkage attatched or not? I have the linkage arms off now because they needed to come off in order to get the brthr box out.

On a side note, the secondaries seemed to be working fine with an occasional studder while engaging.

Again I am in disbelief as to how the car was running so well.....I'm in for a real treat when this is all done huh?

01-20-2008	#1
32valvZ Join Date: Nov 2007 Location: Sunshine State Posts: 1,071	Checking secondary actuators... Ok, so I went down & picked up my new vacuum pump today & checked the actuators. I came up with 15hg needed to fully pull one side & 19hg for the other side. Am I supposed to do this with all the linkage attatched or not? I have the linkage arms off now because they needed to come off in order to get the brthr box out. On a side note, the secondaries seemed to be working fine with an occasional studder while engaging. Again I am in disbelief as to how the car was running so well.....I'm in for a real treat when this is all done huh? __________________ [B]1990 #2815[/B] [COLOR="Red"][B]Red/Red[/B][/COLOR] Ported Plenum & IH (by Pete) Haibeck Chip Rebuilt FPR (by Phil) FIC Injectors Watson LT Headers 3" Stainless Works exhaust Lingenfelter Open Air Lid Bill B Built Transmission Shifter & C Beam Plates [FONT=Impact][COLOR=red]1992 [COLOR=black]#[/COLOR] 091[/COLOR][/FONT] [FONT=Impact][COLOR=#ff0000]Red/[COLOR=silver]Gray[/COLOR][/COLOR][/FONT] [B]SOLD[/B]