04-12-2019 | #1 |
Join Date: Nov 2007
Location: Sunshine State
Posts: 1,071
|
Any Suggestions on This?
So I got the rest of the pipes early from SW. I went to check fitment at lunch and this is where I'm at now.... Still cant hook the headers/cats to the rest of the exhaust. Any idea of what I should do now? Maybe those flex deals?
Just to be clear, its the offset of the pipe to the cats thats the problem. I understand I will need a bit of fab work for the actual proper union of the pipes... I was planning to use a wide band clamp over the end of the pipe & cat to get it down to the shop, but clearly, in this position, I cannot do that...
__________________
[B]1990 #2815[/B] [COLOR="Red"][B]Red/Red[/B][/COLOR] Ported Plenum & IH (by Pete) Haibeck Chip Rebuilt FPR (by Phil) FIC Injectors Watson LT Headers 3" Stainless Works exhaust Lingenfelter Open Air Lid Bill B Built Transmission Shifter & C Beam Plates [FONT=Impact][COLOR=red]1992 [COLOR=black]#[/COLOR] 091[/COLOR][/FONT] [FONT=Impact][COLOR=#ff0000]Red/[COLOR=silver]Gray[/COLOR][/COLOR][/FONT] [B]SOLD[/B] Last edited by 32valvZ; 04-12-2019 at 03:42 PM. |
|
|