LED hedlamp install

[XfireZ51]

Originally Posted by secondchance

least intrusive method I found is to remove fog lamp relay under the passenger side dash, bend the grounding leg sideway and up (so that ground circuit is defeated), solder a wire on the ground leg and finally ground this new wire by hooping it under a 10 mm nut close to bottom of passenger side A pillar/front edge of passenger side door.
Soldering on to relay leg is pretty easy because most, if not all, relay legs have a hole where you can thread a wire before soldering.

Yes but u also mentioned grounding at the fog lamp. Did u do that? If so, how?
Any chance u have pic of where relay is on passenger side?