|
09-13-2018
|
#23 |
 
Join Date: Nov 2007
Location: Sunshine State
Posts: 1,071
|
Re: O2 Sensor Wiring
After much wrestling with the o2 sensor jumper I got from Phil... I finally got it in... man this sucked.... wound up getting it clipped together with the harness through the front of the engine cradle... came loose from the keeper.. Then had to get a wire hangar fish it through and pull it back to the rear of the engine... Sure was hard squeezing my arm down between the upped rad hose and AC pressure line... Good grief... well, using a tapped boss on the side of the engine and a stud that used to keep the heat shield for the cat, its all up and in place...Thats enough for one night for this ole man...
Thanks again Phil.
__________________
[B]1990 #2815[/B] [COLOR="Red"][B]Red/Red[/B][/COLOR] Ported Plenum & IH (by Pete) Haibeck Chip Rebuilt FPR (by Phil) FIC Injectors Watson LT Headers 3" Stainless Works exhaust Lingenfelter Open Air Lid Bill B Built Transmission Shifter & C Beam Plates [FONT=Impact][COLOR=red]1992 [COLOR=black]#[/COLOR] 091[/COLOR][/FONT] [FONT=Impact][COLOR=#ff0000]Red/[COLOR=silver]Gray[/COLOR][/COLOR][/FONT] [B]SOLD[/B] |
|
|
|
|
Threaded Mode