|
09-04-2018
|
#1 |
 
Join Date: Nov 2007
Location: Sunshine State
Posts: 1,071
|
O2 Sensor Wiring
Tried on the other forum... no replies... Anyone know if this is ok?
Thanks, John I will need to lengthen my O2 sensors wiring harness due to adding headers. I have some old O2 sensors. Can I just cut the wires from the old ones and solder them together to get the length I need. Obviously, the wire gauge is the same, so the voltage through them should be consistent. Is this ok to do?
__________________
[B]1990 #2815[/B] [COLOR="Red"][B]Red/Red[/B][/COLOR] Ported Plenum & IH (by Pete) Haibeck Chip Rebuilt FPR (by Phil) FIC Injectors Watson LT Headers 3" Stainless Works exhaust Lingenfelter Open Air Lid Bill B Built Transmission Shifter & C Beam Plates [FONT=Impact][COLOR=red]1992 [COLOR=black]#[/COLOR] 091[/COLOR][/FONT] [FONT=Impact][COLOR=#ff0000]Red/[COLOR=silver]Gray[/COLOR][/COLOR][/FONT] [B]SOLD[/B] |
|
|
|
|
Threaded Mode