Siamese Intake Sealing Woes - ZR-1 Net Registry Forums

Rumblin70SS396 · 10-15-2017

Hello all,

It's been awhile since I have posted here. Unfortunately I have very little time to work on the car so it has been sitting. Any help is appreciated to get this Z up and running again.

A few years ago we replaced the coils, fuel pump, spider and all 16 injectors in this car. The original gaskets had a silicone sealer around each port and the water jackets. I used the paper gaskets available from one of the sponsors here without sealer. Unfortunately almost immediately it was leaking coolant and had a very high idle. After that I shut it down, tucked it in the corner and just got back to it here recently.

Fast forward to present day, I took another set of gaskets and used a non hardening Permatex gasket sealer I have used successfully on other cars. I put the intake back on and torqued the bolts in 20ft lb in the proper sequence. Once the car started, the water issue is gone but the high idle (2k) is still there. I can only assume it's a vacuum leak on the intake as the car never had these issues previously.

What's the best way to seal a siamese intake? Is there something else I am missing? Thanks in advance for any help.

Tony

10-15-2017	#1
Rumblin70SS396 Join Date: May 2017 Location: Delaware Posts: 48	Siamese Intake Sealing Woes Hello all, It's been awhile since I have posted here. Unfortunately I have very little time to work on the car so it has been sitting. Any help is appreciated to get this Z up and running again. A few years ago we replaced the coils, fuel pump, spider and all 16 injectors in this car. The original gaskets had a silicone sealer around each port and the water jackets. I used the paper gaskets available from one of the sponsors here without sealer. Unfortunately almost immediately it was leaking coolant and had a very high idle. After that I shut it down, tucked it in the corner and just got back to it here recently. Fast forward to present day, I took another set of gaskets and used a non hardening Permatex gasket sealer I have used successfully on other cars. I put the intake back on and torqued the bolts in 20ft lb in the proper sequence. Once the car started, the water issue is gone but the high idle (2k) is still there. I can only assume it's a vacuum leak on the intake as the car never had these issues previously. What's the best way to seal a siamese intake? Is there something else I am missing? Thanks in advance for any help. Tony