![]() |
#1 |
![]() Join Date: Jul 2015
Location: Ypsilanti, MI
Posts: 116
|
![]()
Doing a little trunk freshen up on my car, and I had thought the rear shade clips could use a little optimization.
Pulled the old ones out and drew up a version that captures the shade better. Printed using a blend of PLA plastic with 30% carbon fiber. Works great, and should last a while! Picture below of the old and the new. ![]() Sent from my iPhone using ZR-1 Net Registry
__________________
1991 ZR-1 #1438 Black/Black & Red |
![]() |
![]() |
|
|