Fans ON After Plenum Pull - Water Pump Replacement - ZR-1 Net Registry Forums

BigIke · 05-31-2017

Just finished the Water Pump install, put on Jerry's hoses and clamps (Thanks Jerry!!!). While I was in there, I removed the Vacuum Secondary system, with Mark's chip, I didn't need any of that any longer. Just started the car, after filling the system, and squeezing the hoses about 1,000-times.

Gauge was about an 1/8th of the 100-mark, and the heat never got hot:
1. Left water outlet tube = 180deg (temp gun)
2. Right water outlet tube = 140deg
3. From the moment I turned on the car, both fans came on. Note: My chip is set to engage both fans @180 or 170deg.
4. I don't have the AC High-Side tube installed, and the pressure switched are disconnected. Question: Could that cause the fans to run when its cold?
5. The temp sender and switch are connected on the forward driver-side.

Anyone thing of something missed when I did the Water Pump replacement???

Thanks Jay.

05-31-2017	#1
BigIke Join Date: Aug 2014 Location: Montgomery TX Posts: 263	Fans ON After Plenum Pull - Water Pump Replacement Just finished the Water Pump install, put on Jerry's hoses and clamps (Thanks Jerry!!!). While I was in there, I removed the Vacuum Secondary system, with Mark's chip, I didn't need any of that any longer. Just started the car, after filling the system, and squeezing the hoses about 1,000-times. Gauge was about an 1/8th of the 100-mark, and the heat never got hot: 1. Left water outlet tube = 180deg (temp gun) 2. Right water outlet tube = 140deg 3. From the moment I turned on the car, both fans came on. Note: My chip is set to engage both fans @180 or 170deg. 4. I don't have the AC High-Side tube installed, and the pressure switched are disconnected. Question: Could that cause the fans to run when its cold? 5. The temp sender and switch are connected on the forward driver-side. Anyone thing of something missed when I did the Water Pump replacement??? Thanks Jay.