Suspension Troubleshooting

[Billy Mild]

Originally Posted by secondchance

I kept getting code 14 and yet actuator and planetary gear in the actuator looked fine. Eventually I noticed top bushing was squished under the washer/cup. This led me to suspect that the actuator gear was moving up and down excessively during compression/rebound perhaps to a point of binding or disengaging. Replaced the top bushings only (both left and right) with urethane bushing and SRC started to work fine without tripping the code.

Where did you get the new bushings from?

I spoke with Captain Z CNC today on the phone about my SRC issue. He recommend I check to see if there is any play in my actuator gear(checked out fine) using a screwdriver. After that checks out then measure the height of the gear from the top of the cup. This measurement should be 5 MM. Driver side is 6 MM, and the passenger side is 7mm. I'm not sure what the tolerance is, if any for 5 MM. Does anyone know if this is listed in the FSM?