Locobob's Interior Mod Thread - ZR-1 Net Registry Forums

Locobob · 07-26-2014

Did a shake down drive yesterday.... let the problems commence.

Engine RPM whine through stereo speakers

Headlight switch is not lighting up when lights are on

Custom shift boot doesn't fit right, leather binds up when trying to shift into 1st, 3rd and 5th.... back to the upholstery shop grrrr

About 30 minutes into my drive all my new gizmos died. Lost exhaust cut out control, radar detector, TPMS and back-up camera. The common link to these is the I CONV PL 15 amp fuse. The pink/black acc.wire from this fuse provides direct power to the exhaust cut outs and back up camera and also triggers the relay which the radar detector runs off of. My TPMS is powered by an "add a fuse" which is directly plugged into the I CONV PL. Not sure if I'm trying to run too much off this circuit or if something shorted out. I strongly suspect the exhaust cut outs as looking at my diagrams it appears that I forgot to add a secondary fuse on this circuit.

So pretty frustrated at this point, guess I should have done more testing before putting the interior panels back on... time to pull everything back apart arrrrgggg!

07-26-2014	#11
Locobob Join Date: Jan 2004 Location: Portland, OR Posts: 1,057	Re: Locobob's Interior Mod Thread Did a shake down drive yesterday.... let the problems commence. Engine RPM whine through stereo speakers Headlight switch is not lighting up when lights are on Custom shift boot doesn't fit right, leather binds up when trying to shift into 1st, 3rd and 5th.... back to the upholstery shop grrrr About 30 minutes into my drive all my new gizmos died. Lost exhaust cut out control, radar detector, TPMS and back-up camera. The common link to these is the I CONV PL 15 amp fuse. The pink/black acc.wire from this fuse provides direct power to the exhaust cut outs and back up camera and also triggers the relay which the radar detector runs off of. My TPMS is powered by an "add a fuse" which is directly plugged into the I CONV PL. Not sure if I'm trying to run too much off this circuit or if something shorted out. I strongly suspect the exhaust cut outs as looking at my diagrams it appears that I forgot to add a secondary fuse on this circuit. So pretty frustrated at this point, guess I should have done more testing before putting the interior panels back on... time to pull everything back apart arrrrgggg! __________________ Robert ZR-1 Net Registry Oregon State Director 91 ZR-1 #431 Black/Black LPE 368