Question about dipstick seating on the dipstick tube after header install. - ZR-1 Net Registry Forums

5ABI VT · 07-13-2014

My handle feels loose and is off the tube when I check it. The seal is good at the bottom of the tube I ordered a new one from Jerry as well but didn't replace it yet as the one on there seems fine and wasn't hard or brittle and there's no oil around that area (I think I'll change it anyways).

Question is .. Is there a seal or O-ring for the dipstick at the top to seat it on the tube ? After the headers I did have to slightly bend the tube to line up with a header bolt and the tube does slide in relatively easy but won't sit snug. I'd Imagine this wouldn't be a good thing to have it venting/ not sealing.

Any thoughts are appreciated !!

07-13-2014	#1
5ABI VT Join Date: Jun 2013 Location: Toronto Posts: 783	Question about dipstick seating on the dipstick tube after header install. My handle feels loose and is off the tube when I check it. The seal is good at the bottom of the tube I ordered a new one from Jerry as well but didn't replace it yet as the one on there seems fine and wasn't hard or brittle and there's no oil around that area (I think I'll change it anyways). Question is .. Is there a seal or O-ring for the dipstick at the top to seat it on the tube ? After the headers I did have to slightly bend the tube to line up with a header bolt and the tube does slide in relatively easy but won't sit snug. I'd Imagine this wouldn't be a good thing to have it venting/ not sealing. Any thoughts are appreciated !!