Alternator Rubber Boot Replacement

[Dynomite]

Many times you will find the Rubber Insulation Boot located on the HOT wire connection to the Alternator is missing or so brittle it is cracked or not properly connected to the Alternator washer holding the Boot in place.

Alternator Boot.

This Alternator Wire Boot fits perfectly on the main HOT wire of the Alternator connection and clips onto the Alternator Boot Retainer. Use a large FLAT HEAD screw driver to stretch the wire hole in the boot for insertion of the Alternator HOT wire connector. The wire hole in the boot retracts to normal size after wire connector insertion through the hole. This can be accomplished without removing anything from the Top End (The nut holding the HOT wire to the Alternator is removed, Old Boot Removed, New Boot installed, Nut Replaced).

See Alternator Wire Boot