TOP END REFINISHING

[Schrade]

Where's Cliff here - is there a sequence / write-up for vac test with plenum dry - fit, with all electrical connections? Is it in FSM?

Originally Posted by Franke

Schrade, make sure that new O ring is Viton for ethanol fuel. In the pic it looks like a different color from the others and I was wondering if is was Viton or BUNA.

The one in the snappic ON THE INJ is the original one - sheared off. Looks different because it's dry - reason it sheared off too.

Don't know the make of the LT1 kit from which it came...

Originally Posted by Franke

Schrade, looks about right ... not sure why its being difficult. Perhaps its stuck under the plenum. Check post # 37 to see if any help.

I had it mis-routed - post 37 DOES actually show it between 1' and 2' INJ's...